Table of Contents
Advertisement
Machine head
Setting the height
Fig. 43: Setting the height
Setting steps
1. Use the stop screw (3) to limit the height of the burner at the bottom.
2. Use the adjustment setscrew (4) to adjust the upper limit such that
3. Insert the material to be sewn.
4. Check the movement sequence.
5. Adjust the material thickness scanner in relieved condition if necessary:
Fig. 44: Adjusting the material thickness scanner
Service Instructions 911-211 - 00.0 - 02/2015
(3) - Stop screw
there is as little play as possible when the burner is at its topmost
position.
⑥
⑤
(5) - Screws
• Loosen the screws (5) and adjust the height of the material thickness
scanner (6).
• Tighten the screws (5).
(4) - Adjustment setscrew
(6) Material thickness scanner
④
③
49
Advertisement
Table of Contents
