Table of Contents
Advertisement
Machine head
Setting steps
1. Loosen the screw (3).
2. Adjust the mounting plate (2) accordingly.
3. Tighten the screw (3).
4. Switch the machine off and on again.
5. Tap on Service.
6. Input the password (25483).
7. Tap on Multitest > Test inputs/outputs.
8. Push the lever (4) up and monitor the display.
It will show either +103 or -103.
9. Check that the toothed rack still has about 0.5 mm clearance from
10. If necessary, adjust the light barrier using the mounting plate.
Service Instructions 911-211 - 00.0 - 02/2015
the stop.
33
Advertisement
Table of Contents
