Machine head
Fig. 31: Setting the presser foot height
(1) - Screw
(2) - Nut
Setting steps
1. Loosen the screw (3).
2. Turn the pivot shaft so that the distance between throat plate and
3. Tighten the screw (3).
4. Turn the sewing foot to top dead center.
The distance between the throat plate and sewing foot must be
5. Undo the nut (2).
6. Adjust the screw (1) so that the distance between the throat plate and
Service Instructions 911-211 - 00.0 - 02/2015
①
sewing foot is 1 mm.
5 mm.
sewing foot is 5 mm (corresponding to a 4 mm sewing foot stroke).
Notice
The distance between min. and max. positions may have to be deter-
mined. If one of these settings is changed the other setting must be
checked again.
②
③
(3) - Screw
37