Scanning A Folded Original ([Z-Folded Original]); Scanning While Removing Dust In The Slit Glass ([Despeckle]); Scanning A Number Of Originals In Several Batches ([Separate Scan]) - Muratec MFX-C2280 User's Manual Copy Operations

Scanning a folded original ([Z-Folded Original])

The size of the original - even folded originals - can be detected accurately.
If a folded original is loaded into the ADF, the size of the original may not be detected properly. To scan a
folded original through the ADF, use [Z-Folded Original].
For details, refer to page 15-19.
NOTICE
Unfold folded originals before loading them into the ADF. If a folded original is not unfolded before scanning,
a paper jam or an erroneous size detection may occur.

Scanning while removing dust in the slit glass ([Despeckle])

When scanning an original that has been placed into the ADF, scanning of the original and removal of dust
from the Slit Scan Glass are performed alternately so that the original is always scanned on clean Slit Scan
Glass.
It takes longer to finish scanning, compared to the normal operation.
For details, refer to page 15-20.

Scanning a number of originals in several batches ([Separate Scan])

If the number of original sheets is so large that they cannot be loaded into the ADF at the same time, you can
load them in several batches and handle them as one job.
In [Separate Scan], you can switch between the ADF and the Original Glass for scanning the originals.
1
Load the original.
NOTICE
Do not load more than 100 sheets at a time into the original tray, and do not load the sheets up to the
point where the top of the stack is higher than the , mark. Doing so may cause an original paper jam,
damage the originals, and/or load to the ADF failure.
Specifying the Original Size and Scan Method
7
7-4