Starting Clientview To Start Configuring Switch - Dialogic IMG 1004 Quick Start Manual


SS7 links are brought in over the Bearer Ports

Starting ClientView to start Configuring Switch

Once the IMG 1004 has software installed, the cabling is connected, and the GCEMS server has been configured then the
ClientView application can be used to configure the IMG 1004. Below are a few topics from Online documentation to get you
started on configuring the IMG 1004 through the ClientView GUI

Configuration > ClientView > (All topics under this book)

Configuration > Introduction

Configuration > Node Configuration Wizard

Configuration > Basic Configuration
From here you are ready to configure the IMG 1004 for your network. Use the Online Manual Configuration, Clientview, and
ClientView Pane sections to configure the IMG 1004.
Dialogic Corporation
IMG 1004 Quick Start Guide
Part # 07-8724-00 Page 7 of 7