Configuring The Printer For The Network Using The Control Panel - Ricoh CL7000 Setup Manual

Configuring the Printer for the Network
using the Control Panel
You must make printer settings using
the control panel to use it in a net-
work environment.
The following list shows the items
you can set and their default values.
Reference
For information about the "Host
Interface" menu, see " Host Inter-
face Menu", Administrator Refer-
ence (PDF file on the CD-ROM
labeled "Operating Instructions").
Setting Name
DHCP
*1
IP address
*1
Subnet mask
*1
Gateway address
Frame type (NW)
(frame type Net-
Ware)
Active protocol
Ethernet
*1
If DHCP is in use, IP address, subnet
mask, and gateway address are auto-
matically set.
❍ means the protocol is active.
*2

Configuring the Printer for the Network using the Control Panel

Default
On
011.022.033.044
000.000.000.000
000.000.000.000
Auto
❍
*2
TCP/IP
❍
*2
NetWare
❍
*2
NetBEUI
❍
*2
AppleTalk
Auto
A A A A
Press { { { { Menu} } } } .
On Line Menu
Job Reset Form Feed
Power Error
The menu appears on the display.
B B B B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Host
Interface" and then press { { { { Enter #} } } } .
Menu:
Host Interface
The interface setting menu ap-
pears.
C C C C
The procedure below describes
how to set TCP/IP. Make settings
for other items by following the
same procedure.
Note
❒ The default settings for all pro-
tocols are "Active".
❒ You are recommended to set
unused protocols "Not Active".
A Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Network Setup", and then
press { { { { Enter #} } } } .
Host Interface:
Network Setup
Escape
#
Enter
Data In
ZDJS001N
27
3