Loading Paper; Loading Paper In Tray 1 - Ricoh CL7000 Setup Manual

Setting Up

Loading Paper

This section describes how to load pa-
per in the paper tray. If you do not
load paper, the setup procedure will
not be properly complete.
The side guide and end guide of each
2
paper tray is set to the following val-
ues at factory default. The loading
procedure is different if you choose to
load paper that is a different size from
that of factory default.
See p.18 "Loading Paper in Tray 1".
❖ ❖ ❖ ❖ Default of the paper tray
• Tray 1 (standard): 11 × 8 1/2K
only
• 2000-sheet Large Capacity Tray
(optional): 11 × 8 1/2K only
For details about size and feed orien-
tation of paper that can be loaded in
the tray, see "Paper and Other Me-
dia", Maintenance Guide.
For details about loading paper in the
bypass tray, see "Loading Paper in
the Bypass Tray", Maintenance Guide.
18

Loading Paper in Tray 1

Important
❒ Tray 1 is 11 × 8 1/2K paper only.
Load only 11 × 8 1/2 size paper.
A A A A
Slowly slide the paper tray out,
until it stops.
B B B B
Align all four sides of the paper
stack, and then load it in the tray.
Important
❒ Make sure the top of the stack is
not higher than the limit mark
inside the tray.
❒ Be sure to adjust the side guides
according to the paper size, or
paper misfeeds might occur.
C C C C
Slowly slide the paper tray back,
until it stops.
ZDJH003J
ZDJY001J