Paper Feed Unit; Installing The Paper Feed Unit Type 3800C (500 × 1) - Ricoh CL7000 Setup Manual

Installing Options

Paper Feed Unit

Preparation
If you want to use the optional du-
plex unit, 2 tray finisher or 4-bin
mailbox at the same time, install
the optional paper feed unit first,
and then install these options.
If you have already installed the
optional duplex unit, 2 tray finish-
er and 4-bin mailbox, remove all
these options before installing the
optional paper feed unit.
4
Important
❒ Before installation, check the ori-
entation of the paper feed unit or
2000-sheet Large Capacity Tray
you want to place.
❒ When installing multiple options,
install the paper feed unit first.
❒ Four people are needed to install
the paper feed unit. Start installa-
tion when all four people are
ready.
R CAUTION:
• When moving the machine, each
person should hold a handle, lo-
cated on two sides of the printer,
and then lift slowly. Lifting care-
lessly or dropping it may cause
injury.
Note
❒ The printer weighs approximately
85 kg (187 lbs).
38
Installing the Paper Feed Unit
Type 3800C (500 × × × × 1)
R CAUTION:
• When moving the paper feed
unit, hold the bottom of both
sides, and then lift slowly. Lifting
carelessly or dropping it may
cause injury.
Note
❒ The 500-sheet paper feed unit
weighs approximately 18 kg (39.7
lbs).
A A A A
Turn off the power, and then un-
plug the power cable.
B B B B
Remove the adhesive tape.
C C C C
Adjust the four corners of the
printer to those of the 500-sheet
paper feed unit, and then lower
the printer slowly into place.
ZDJP004J
ZDJP006J