802.11B Interface Unit Type A - Ricoh CL7000 Setup Manual

802.11b Interface Unit Type A

Important
❒ Before handling the 802.11b inter-
face unit, ground yourself by
touching something metal to dis-
charge any static electricity. Static
electricity can damage the 802.11b
interface unit
❒ Do not subject the 802.11b interface
unit to physical shocks.
Limitation
❒ The 802.11b interface unit and
Ethernet interface cannot be used
at the same time.
❒ If problems occur with printing
due to of poor radio reception,
connect an external antenna.
A A A A
Check the contents of the box.
❖ ❖ ❖ ❖ 802.11b Interface Unit Type A
• Interface Unit
• Card
B B B B
Turn off the power, and then un-
plug the power cable and inter-
face cable.
C C C C
Slowly open the front cover of the
printer, remove the green screw-
driver, and then close the cover.
Reference
p.37 "Using the Screwdriver"
D D D D
Remove the two screws fastening
the controller board to the back of
the printer using the provided
screwdriver.
ZHBP410E
The removed screws will be used
later to fasten the controller board.
802.11b Interface Unit Type A
ZHXP240J
ZDJP025J
4
57