Table of Contents
Advertisement
General Installation Process
15
Remove the Top Cover
A
Remove four screws.
B
Lift the cover upwards from B edge
and pull to detach the latches.
A
Note: Before removing the top cover, turn off all peripheral devices connected to
the server, turn off the server, and disconnect the power cord.
17
Software
•
A.
Update the System Software:
1. Boot from the Intel
®
Server Deployment Toolkit CD.
2. Use the Wizard to access the latest versions on the Internet and update the BIOS, firmware, FRUSDRs, and Intel
Note: The FRUSDR utility must be run for full server configuration.
B. Configure your RAID Controller:
If using a RAID card, use the instructions provided with the RAID controller. If using on-board RAID, you must activate RAID in the BIOS setup. See the Intel
S2600GZ/GL Technical Product Specification for more information.
C. Install your Operating System:
Use the instructions provided with the RAID controller and with the operating system.
D. Install Operating System Drivers:
With the operating system running, insert the Intel
allow you to select the appropriate drivers to install. On other operating systems, browse the CD folders to locate and install the driver files.
E. Install Intel® System Management Software (optional):
Download the latest version of the Intel
install the software.
* Other brands and names may be claimed as the property of others..
B
BIOS, Drivers, and Operating System Installation
®
Server Deployment Toolkit CD. If using a Microsoft Windows* operating system, the Express Installer will autorun and
System Management Software from
®
16
Install Top Cover
A
Place system cover onto the chassis and engage recessed edge at
rear of cover.
B
Put down the cover from B edge
and tighten the screw at front.
B
®
RMM4. Note: You may also download files on a USB key.
http://www.intel.com/go/servermanagement
10
A
Server Board
®
and use the instructions provided at that link to
Advertisement
Table of Contents
