Sony PXW-X320 Operating Instructions Manual page 148

MAINTENANCE
Item
Auto Iris2
Makes settings related to
auto iris.
Flicker Reduce
Makes settings related to
flicker reduction.
Reduces the flicker that
can occur when a subject
is shot under a light
source with a periodically
varying brightness, such
as fluorescent lights, due
to the relationship with
the camcorder's
recording frame rate.
Genlock
Makes settings related to
genlock.
Sub-item Setting
1/2/3/4/5/6/Var
Iris Window
Iris Window Ind On/Off
–99 to ±0 to +99
Iris Level
Iris APL Ratio –99 to ±0 to +99
40 to 500 to 999
Iris Var Width
Iris Var Height 70 to 500 to 999
–479 to 0 to +479
Iris Var H
Position
Iris Var V –464 to 0 to +464
Position
–99 to ±0 to +99
Iris Speed
Clip High Light On/Off
Mode Auto/On/Off
Frequency 60Hz/50Hz
H Phase(HD) –999 to ±0 to +999
H Phase(SD) –99 to ±0 to +99
Reference Internal/Genlock
Description
Selects the auto iris detection window
type.
Var: Variable
Turns the indication of the auto iris
detection window frame on/off.
Adjusts the level of the auto iris target
value.
Adjusts the mix ratio of auto iris
detection peak value and average value.
(Available when "OPERATION" >
"TLCS" > "Mode" is set to "Standard")
Adjusts the width of the detection
window when "Iris Window" is set to
"VAR."
Adjusts the height of the detection
window when "Iris Window" is set to
"VAR."
Specifies the horizontal position of the
detection window when "Iris Window"
is set to "VAR."
Specifies the vertical position of the
detection window when "Iris Window"
is set to "VAR."
Specifies the control speed (speed of
reaction to changes in the video).
(Larger values specify quicker reaction
times.)
Turns on/off the function that disregards
highlights and forces a flatter reaction to
high luminance.
Enables or disables flicker reduction.
On: Always enabled.
Auto: Enabled when flicker is detected.
Off: Disabled
Set to the frequency of the lighting
fixture that is causing the flicker. (The
factory default setting is "50 Hz" when
"Country" is set to "PAL Area,"
"60 Hz" when "Country" is set to other
than "PAL Area.")
Specifies the H phase of HD output
when genlock is enabled.
Specifies the H phase of SD output
when genlock is enabled.
Displays the type of reference signal
used by the camcorder.
148