Saving And Loading Lens Files; Setting Lens File Data; Saving Lens Files; Loading Lens Files - Sony PXW-X320 Operating Instructions Manual

Saving and Loading
Lens Files

Setting Lens File Data

Set the data in lens files on "FILE" (see page 156)
"Lens" in the setup menu .
You can set the following data and save it as a
lens file.
Settings data
V modulation shading
compensation values
Center marker position
Flare level
White balance
compensation value
White shading
compensation value
For details about menu operations, see "Basic Setup
Menu Operations" (page 110).

Saving Lens Files

Insert an SxS memory card into a memory card
slot, then proceed as follows.
For details about menu operations, see "Basic Setup
Menu Operations" (page 110).
1
Select "FILE" > "Lens" in the setup
menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see "To assign names to files"
(page 165).
2
Select "Lens Store SxS" > "Execute,"
and press the MENU knob.
When saving to internal memory, select
"Lens Store Mem" > "Execute." When
Sub-item
M V Modulation
Lens Center H
Lens Center V
Lens R Flare
Lens G Flare
Lens B Flare
Lens W-R Offset
Lens W-B Offset
L R/G/B H Saw
L R/G/B H Para
L R/G/B V Saw
L R/G/B V Para
168
saving to a USB flash drive (UDF, exFAT
modes), select "Lens Store USB" >
"Execute."
3
Press the MENU knob.
A list box of lens file number appears. File
numbers where "No File" is displayed are
empty file numbers.
File numbers with a file name or a date and
time are the number of files that already
contain data.
4
Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5
To execute the save, select "Execute,"
and then press the MENU knob.
To cancel the save, select "Cancel," and
then press the MENU knob.
If you selected Lens Store SxS in step 2, the
ACCESS lamp lights when you execute the
save (in blue on the right-side panel and in
orange in the card slot section). When the
data has been saved to the SxS memory card,
a completion message appears and the
ACCESS lamp goes out.
If saving to internal memory or a USB flash
drive, the ACCESS lamp does not light up.

Loading Lens Files

Insert an SxS memory card into a memory card
slot, then proceed as follows.
For details about menu operations, see "Basic Setup
Menu Operations" (page 110).
1
Select "FILE" > "Lens" in the setup
menu.
2
Select "Lens Recall SxS" > "Execute."
When loading from internal memory, select
"Lens Recall Mem" > "Execute." When
loading from a USB flash drive (UDF,
exFAT modes), select "Lens Recall USB" >
"Execute."
3
Press the MENU knob.
A list box of lens file number appears. File
numbers where "No File" is displayed are
empty file numbers.