Removing The Microprocessor - IBM System x3250 4364 Problem Determination And Service Manual

Removing the microprocessor

To remove the microprocessor, complete the following steps.
60
IBM System x3250 Types 4364, 4365, and 4366: Problem Determination and Service Guide
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 25.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables necessary to replace the device.
3. Remove the server from the rack; then, remove the cover (see "Removing the
cover" on page 28).
Heat-exchanger-assembly
release latch
4. Remove the air baffle.
5. Open the heat-exchanger-assembly release latch to the fully open position.
6. Lift the side of the heat-exchanger assembly that is closer to the middle of the
server, slide it toward the middle of the server slightly, and lift the entire
assembly out of the server.
Microprocessor
release latch
Air baffle
Heat-exchanger
assembly
Microprocessor
bracket frame