Installing A Hot-Swap Hard Disk Drive - IBM System x3250 4364 Problem Determination And Service Manual
Hide thumbs
Also See for System x3250 4364:
- Installation manual (76 pages) ,
- User manual (74 pages) ,
- Problem determination and service manual (142 pages)
Table of Contents
Advertisement
To remove a hot-swap hard disk drive, complete the following steps.
Drive-tray assembly
Drive handle
(in open position)
Attention:
To avoid damage to the hard disk drive connectors, make sure that the
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
1. Move the handle on the drive to the open position (perpendicular to the drive).
2. Pull the hot-swap drive assembly from the bay
Installing a hot-swap hard disk drive
To install a hot-swap hard disk drive, complete the following steps.
Note: If you have only one hard disk drive, install it in the left or upper-left drive
bay.
Chapter 4. Removing and replacing server components
37
Advertisement
Table of Contents
