Important Information; Safety Information; General Recommendations - Barco Eonis MDRC-2122 WP User Manual

22–inch clinical display
Hide thumbs Also See for Eonis MDRC-2122 WP:
Table of Contents

Advertisement

7. IMPORTANT INFORMATION

7.1

Safety information

General recommendations

Read the safety and operating instructions before operating the device.
Retain safety and operating instructions for future reference.
Adhere to all warnings on the device and in the operating instructions manual.
Follow all instructions for operation and use.
Electrical Shock or Fire Hazard
To prevent electric shock or fire hazard, do not remove cover.
No serviceable parts inside. Refer servicing to qualified personnel.
Do not expose this apparatus to rain or moisture.
Modifications to the unit:
Do not modify this equipment without authorization of the manufacturer.
Type of protection (electrical):
Display with external power supply: Class I equipment.
Degree of safety (flammable anesthetic mixture):
Equipment not suitable for use in the presence of a flammable anesthetic mixture with air or with oxygen
or nitrous oxide.
Non-patient care equipment
Equipment primarily for use in a health care facility that is intended for use where contact with a patient
is unlikely (no applied part).
The equipment may not be used with life support equipment.
The user should not touch the equipment, nor its signal input ports (SIP)/signal output ports (SOP)
and the patient at the same time.
Power connection – Equipment with external 12 VDC power supply
Power requirements: The equipment must be powered using the delivered medical approved 12 VDC
(
) power supply.
The medical approved DC (
The power supply is specified as a part of the ME equipment or combination is specified as a ME
system.
To avoid the risk of electric shock, this equipment must only be connected to a supply mains with
protective earth.
The equipment should be installed near an easily accessible outlet.
The equipment is intended for continuous operation.
Transient over-voltage
If the device is not used for a long time, disconnect it from the AC inlet to avoid damage by transient
over-voltage.
K5903049 EONIS 25/06/2015
) power supply must be powered by the AC mains voltage.
7. Important information
23

Advertisement

Table of Contents
loading

Table of Contents