Windows Nt 4.0 Dhcp Server; Verifying The Installation Of The Dhcp Server - Avaya 4600 Series Administrator's Manual

In Table 3, the 4600 Series IP Telephone sets the system values to the DHCPACK message
field values shown.
Table 3: DHCPACK Setting of System Values
System Value
IPADD
NETMASK
GIPADD
TFTPSRVR
The rest of this section describes some common DHCP servers.

Windows NT 4.0 DHCP Server

This section contains details on how to verify and configure the DHCP server included in the
®
Windows NT
Use

Verifying the Installation of the DHCP Server

If it is not, install the DHCP server. If it is installed, go to the section
page 54 and the subsequent sections.
Verifying the Installation of the DHCP Server
Use the following procedure to verify whether the DHCP server is installed.
1. Select Start
2. Double-click the Network icon.
3. Verify that Microsoft DHCP Server is listed as one of the Network Services on the Services
tab.
4. If it is listed, go to the following section,
DHCP server.
4.0 server operating system.
Settings Control Panel.
--> -->
Set to
The yiaddr field.
Option #1 (if received).
The first four octets of Option #3 (if received).
The first four octets of the siaddr field.
to verify whether the DHCP server is installed.
Initial Configuration. If it is not listed, then install the
Initial Configuration on
Issue 2.2 April 2005
DHCP
53