Section 2: Assembly and Installation
Note: Before deploying the camera to a fixed location, you should take a photo from the intended location to make sure the camera
will have an adequate field-of-view.
Step 1
Place the Alignment Sticker in the intended location for your
camera, making sure you allow sufficient space for both
the DCS-6315 and the wire-in bracket. You can refer to the
diagrams for
"Dimensions" on page
Step 2
Use a 6mm drill bit to make required holes approximately
30mm deep.
Step 3
Remove the Alignment Sticker.
Step 4
Insert wall anchors and attach the mounting plate, using the
screws provided.
D-Link DCS-6315 User Manual
Deploying the Camera
71.
13