Icr And Ir - D-Link DCS-6315 User Manual

Section 3: Configuration
You can configure the ICR (Removable IR-Cut Filter) and IR (Infrared
Light Control) settings. When the ICR filter is switched on, it
blocks infrared light and allows only visible light to pass through.
The ICR filter is disengaged for increased sensitivity in low-light
environments.
Automatic: Click Automatic if you want the Day/Night mode
to be set automatically. Generally, the camera will
use Day mode and switch to Night mode when it
gets dark.
Day Mode: Click Day mode to enable the IR Cut Filter.
Night Mode: Click Night mode to disable the IR Cut Filter.
Click Schedule mode to set up the Day/Night
Schedule
Mode:
mode using a schedule. Select a starting time for
the camera to enter Day mode, and an ending
time for the camera to change to Night mode.
IR Light
The camera can enable or disable the IR (infrared)
Control: light control according to the light conditions.
Click on Automatic and make a selection from the
drop-down menu.
Click Off so the IR light control is always disabled.
Off:
Click On so the IR light control is always enabled.
On:
Sync with ICR: The IR light will turn on when the ICR sensor is on.
Click Schedule so the IR light control will turn on
Schedule:
or off according to the schedule that you specify.
Click Save Settings.
D-Link DCS-6315 User Manual

ICR and IR

DCS-6315
59