Part Names - Sanyo VSP-8000 Instruction Manual

PART NAMES

Operation panel
P
1
ALARM LIST button ( P43)
Press to display the alarm data for each device.
2
ALARM lamp ( P43)
Lights to notify you if an alarm occurs at a device.
3
STATUS LIST button ( P44)
Press to display the status data for each device.
4
STATUS lamp ( P44)
Lights to notify you if the status of a device changes.
5
MODE button
Press to select the device (multiplexer etc.) to operate.
6
INDIVIDUAL button ( P20, 25, 29, 34)
Press for separate operation of individual devices.
7
GROUP button ( P38)
Press to operate a group of devices simultaneously.
8
Menu screen
When the power switch on the rear panel is turned on, the
screen shown below is displayed. A denotes the section
where the date and time are displayed when they are set.
Also, when the operation buttons are pressed, the operating
status and settings are displayed here.
S A N Y O C o n t r o l l e r
- - : - - : - -
A
9
FUNCTION button ( P22, 27, 32, 36)
Press to operate the various devices by calling up their
commands.
F
CLEAR button
Press to clear what you have entered.
1 23 4 5
O
6 7 8
N L M
G
MENU button ( P7)
Press to bring up the menus. Switches between the menu
display and initial display each time pressed.
H
AF button
Press to focus the camera automatically with a single button
press.
I
ZOOM lever
Use to carry out electronic zooming.
J
ENTER button
Press to enter and finalize the settings.
K
Joystick lever
Tilt up, down and to the left and right to move the cursor.
Used to carry out tilt and pan operations when using the
camera.
Note: Do not use unnecessary force or else the lever or switch
may be damaged.
L
Plus (+) and minus (–) buttons
Press to switch between menus and select settings.
M
Numeric keypad (0 to 9)
Press to enter alphanumeric characters and symbols.
N
CAMERA command button ( P29)
Press for camera operation.*
O
MULTIPLEXER command button ( P20)
Press for multiplexer operation.*
P
TIMELAPSE VCR/DIGITAL VIDEO RECORDER
command button ( P25, 34)
Press for timelapse VCR or digital video recorder operation.*
* In order to allow operation of command buttons N, O and P,
a serial communication terminal (either a RJ-11 or Push-lock
terminal) is required.
3
9 F
N G K H I J