Sanyo VSP-8000 Instruction Manual page 38

DIGITAL VIDEO RECORDER OPERATION
Call-up command operation list
The in the table tells you the corresponding section below for reference.
Call-up command
CLOCK ADJUST Sets minutes and seconds of clock to 00
COPY Copies still images to the archive recording area or to a CompactFlash card
MENU RESET
Returns menu screen settings to initial values
TIMER ON/OFF
Sets timer recording standby mode
ZOOM
Turns the zoom function on and off
Note: If the connected device does not have command functions, then "No OPE" will appear in the menu screen.
Operations
A: CLOCK ADJUST
Sets minutes and seconds of clock to 00
Ex.: Set clock to 14:00:00
Works over the range from 13:30:00 to
14:29:59.
1.
Press the + (or – ) button to select
"CLOCK ADJUST".
2.
Press the ENTER button.
D R : 0 0 1 C L K A D J .
P R E S S : [ E N T E R ]
3.
Press the ENTER button again.
D R : 0 0 1 C L K A D J .
Operation
B: COPY
Copies still images to the archive recording
area or to a CompactFlash card
1.
Press the + (or – ) button to select
"COPY".
2.
Press the ENTER button.
Enables copy setting mode. Jog/shuttle
dial operations will be displayed on the
monitor screen.
D R : 0 0 1 C O P Y
E X I T : C L E A R
3.
Use the joystick lever to make copy
settings.
Press the CLEAR button and return to the
call-up command selection display.
C: TIMER ON/OFF
Sets a recording program on the menu
screen. (Please refer to the digital video
recorder instruction manual.)
1.
Press the + (or – ) button to select
"TIMER ON/OFF".
2.
Press the ENTER button and return the
menu screen to its normal screen.
Recording is programmed.
3.
Press the + (or – ) button to select
"TIMER ON/OFF".
4.
Press the ENTER button again.
Recording program is cancelled.
D R : 0 0 1 T . O N / O F F
37
Menu screen
( A)
DR:001
( B) COPY
DR:001
( C)
( D)
D: ZOOM
Turns the zoom function on and off
1.
Press the + (or – ) button to select
"ZOOM".
2.
Press the ENTER button.
Enables zoom setting mode. Jog/shuttle
dial operations will be displayed on the
monitor screen.
D R : 0 0 1 Z O O M
E X I T : C L E A R
3.
Use the joystick lever to make zoom
settings.
•
Jog: Set the zoom position by moving
the joystick lever up/down
•
Shuttle : Confirm the zoom position by
moving the joystick lever to the right
Press the CLEAR button and return to
the call-up command selection display.
Note:
•
When the zoom position is specified,
the zoom screen display will appear
automatically on the monitor screen.
•
Repeat these commands to cancel
the zoom screen display.
MENU RST