Casablanca Metropolitan Owner's Manual page 11

notE: W-85 Wall Control should only be installed on Casablanca's Inteli-Touch
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This
controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this
reason the following precautions must be observed:
1. u se only the Casablanca W-85 wall control.
2. d o not use any additional control with your Inteli-
Touch 3 fan (for example, dimmer, or fan speed
control).
ensure power is turned OFF at the breaker or fuse panel before starting installation.
W-85 is used to describe either white (-11) or almond finish.
If you have multiple Inteli-Touch 3 fans, refer to the section
"Changing Frequency Setting" on page 13.
1. R emove the screws and switch plate from the existing
switch box.
2. R emove the screws holding the switch in the switch box.
3. P ull the existing switch from the switch box to expose
the wire connections.
4. R emove the two wires from the switch.
5. C onnect the bLACK wire from the POWeR SOuRCe
that you just removed from the switch to the bLACK/
WHITe STRIP wire on the W-85 wall control. Secure
this connection with a wire nut.
notE: The Red wire is not used in this
application, dO NOT remove the crimped cap
from the wire..
6. C onnect the second bLACK wire that you
just removed from the switch to the second
bLACK wire on the located on the back of
the W-85 wall control. Secure this connection
with a wire nut.
7. C onnect the green ground wire coming from
the back of the W-85 control to the ground
wire in the switch box. Secure the splice with
a wire nut.
8. C heck your work by using the wiring
diagrams as shown in Figures # 1 and #2.
9. Install the W-85 in the wall box with the two
long screws provided.
10. Install the wall plate with the two color-
matched screws.
3
®
W-85 ContRol inStallation
inStalling thE W-85 Wall ContRol
single W-85 installation
CaUtion!
3 fans with dOWNLIgHTS ONLY.
®
3. d o not use more than one fan per wall control.
4. N o other light fixtures or electrical appliances may
be connected on the circuit controlled by the W-85
wall control.
W-85
2 BlaCK
WiRES
(FigURE #2)
(FigURE #1)
W-85
Wall Control
RED WiRE
not USED
BlaCK anD WhitE
StRiPED WiRE
11