Operation Lights - Casablanca Metropolitan Owner's Manual

The button is normally left in the on position. Always turn the power off
during cleaning or servicing the fan and during thunderstorms. It is also used to
exit or enter additional programs.
The button must be left on to retain a previously set fan speed or light level.
There are six individual speed settings for the fan; each speed is indicated
by an audible tone of increasing pitch.
To select the desired fan speed:
1. With fan off, press and hold the button labeled
will start rotating at the slowest speed, and will increase in steps.
2. Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the
same speed each time the
of speed, turn the fan on by pressing
lower speed, turn fan off, then on by pressing and holding the
button until the desired speed is reached. When the fan is on, you may
increase the speed by pressing and holding the
desired speed is reached, then release it.
The direction of airflow can be changed from down-
ward to upward or from upward to downward.
To reverse the airflow:
1. make sure the
ing.
2. Press the
To turn the lights off and on, press and release the
one second.
1) First press/release of the
2) Second press/release of the
To vary the light brightness at each touch level:
to vary the light brightness:
1. With lights off, press and hold the button. After one second the lights will
come on at their lowest level and gradually become brighter.
notE: Light Operation - the light varies from "bright" to "dim" over
approximately 8 seconds. This sequence will reverse the light when it reaches
the brightest or dimmest level if you continue to hold the LIgHT button.
Release the button when the desired level is reached.
2. Release the button when the desired brightness level is reached.
The brightness level is now in the fan memory and will automatically come on at
the same brightness the next time the button is used.
12
3
®
oPERation PoWER
oPERation SPEED ContRol
button is used. To maintain this level
less than one second. To
oPERation REvERSing aiRFloW
is on and blades are Turn-
button.

oPERation lightS

button- The light will turn ON.
button- The light will turn OFF.
fAn ConTRol
ON - OFF:
. The fan blades
A momentary
press of the FAN
ChAngE SpEED:
Press and hold
FAN button longer
than one second
button until the
note: A four-toned signal
indicates the command was
accepted by the fan. A few
seconds later the fan will slow
to a stop and then reverse
direction.
button for less than
button
lIghT ConTRol
on - oFF:
A momentary press of
the light button
ChangE BRight-
nESS:
PRESS anD holD
light BUtton
longER than onE
SEConD