Daily Operation; Getting Started; Lighting A Fire - England's Stove Works Smartstove 25?SSP01 Installation & Operation Manual

Getting Started

Check to see that the hopper is clean and free from foreign materials. Be sure to connect this unit to a working
outlet; we recommend using a surge protector to help protect the electronic components from damage.

BEFORE your first fire, dry run your unit (no pellet fuel in the hopper) for twenty minutes; pressing the "ON" button
with the unit plugged in will initiate the dry run.

Once the "ON" button is pressed, you should immediately hear the exhaust blower start and operate
continuously. A default set temperature will appear in the window of the control board.

After about three to five minutes, look for the red glow of the igniter in the igniter port of the burn pot to be
certain it is operating normally.

Hold the hopper lid switch (See "Illustrated Parts Diagram" pg. 45) down with your finger and check to see
that the auger is turning. Release the hopper lid switch and be certain that the auger stops turning. DO
NOT PUT YOUR FINGERS IN THE HOPPER OR NEAR THE ROTATING AUGER.

After about twenty minutes, the control board should display "FS" in the two display windows (More information on
Error Codes can be found in the Error Code section of this manual).

At this point, the dry run is complete and your pellet heating appliance is ready for normal operation.
Lighting a Fire

In order for this stove to operate, the hopper must first be filled with pellet fuel. Lift the hopper lid using the flush‐
mount handle and pour the pellet fuel directly into the hopper.
 We recommend using only pellets manufactured by PFI Certified facilities, since pellets bearing the PFI
stamp of approval will be low in ash and moisture, high in BTU's, and uniform in size and quality.

This pellet stove will perform equally well using softwood and hardwood pellets, and although the ash may differ
slightly in appearance or texture, both types of pellets will burn cleanly and efficiently in this stove.

This pellet stove is equipped with an automatic pellet ignition system; the only user input required to light the stove
is a simple press of the "On" button.

After pressing the "On" button, the most recent setting will appear in the window of the control board. This
indicates the stove has entered the start‐up sequence and is operating normally.

The fuel feed rate and combustion air during start‐up is determined by the control board, so the stove may be
started on any heat range.
 After approximately fifteen minutes, the fire should be burning brightly. At this point, the stove has begun
normal operation and the display windows on the control board will display your setting, unless the Heat
Range or Blower Speed is adjusted.
 It is normal for the unit to smoke during the first fire, as paints and oils cure. This should dissipate within
the first hour. Open a door and/or window during the first fire to ventilate the area.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
DAILY OPERATION
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
17