Daily Operation; Getting Started; Lighting A Fire - England's Stove Works 25-CBPAH Installation & Operation Manual

Getting Started
 Check to see that the hopper is clean and free from foreign materials. Be sure to connect this unit to a
working outlet; we recommend using a surge protector to help protect the electronic components from
damage.
 BEFORE your first fire, dry run your unit (no pellet fuel in the hopper) for twenty minutes; pressing the
"ON" button with the unit plugged in will initiate the dry run.
 Once the "ON" button is pressed, you should immediately hear the exhaust blower start and
operate continuously.
 After about three to five minutes, look for the red glow of the igniter in the igniter port of the burn
pot to be certain it is operating normally.
 Hold the hopper lid switch (See "Illustrated Parts Diagram" pg. 44) down with your finger and check
to see that the auger is turning. Release the hopper lid switch and be certain that the auger stops
turning. DO NOT PUT YOUR FINGERS IN THE HOPPER OR NEAR THE ROTATING AUGER.
 After about twenty minutes, the control board should display "E‐2" in the two display windows (More
information on Error Codes can be found in the Error Code section of this manual).
 At this point, the dry run is complete and your pellet heating appliance is ready for normal operation.
Lighting a Fire
 In order for this stove to operate, the hopper must first be filled with pellet fuel. Lift the hopper lid using
the flush‐mount handle and pour the pellet fuel directly into the hopper.
 We recommend using only pellets manufactured by PFI Certified facilities, since pellets bearing
the PFI stamp of approval will be low in ash and moisture, high in BTU's, and uniform in size and
quality.
 This pellet stove will perform equally well using softwood and hardwood pellets, and although the ash may
differ slightly in appearance or texture, both types of pellets will burn cleanly and efficiently in this stove.
 This pellet stove is equipped with an automatic pellet ignition system; the only user input required to light
the stove is a simple press of the "On" button.
 Shortly after pressing the "On" button, the letters "S U" will appear in the heat range and blower speed
windows of the control board. This indicates the stove has entered the start‐up sequence and is operating
normally.
 The fuel feed rate and combustion air during start‐up is determined by the control board, so the stove may
be started on any heat range.
 After approximately fifteen minutes, the fire should be burning brightly and the "S U" should disappear
from the control board. At this point, the stove has begun normal operation and the display windows on
the control board will remain empty, unless the Heat Range or Blower Speed is adjusted.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
DAILY OPERATION
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
18