HP ProDesk 400 G2.5 Maintenance And Service Manual page 43

●
If you are installing a 2.5-inch hard drive, place the drive in the drive cage (1) and secure the drive
with four M3 metric screws (2).
NOTE: The four screw holes for the 2.5-inch hard drive are stamped "B" on the top of the drive
cage.
8. Hold the drive cage at an angle and insert the tabs on the side of the drive cage into the slots on the
chassis (1), and then lower the other side of the drive cage down so that the latch snaps onto the
chassis (2).
Drives 35