Removing A 9.5Mm Slim Optical Drive - HP ProDesk 400 G2.5 Maintenance And Service Manual

Removing a 9.5mm slim optical drive

CAUTION:
computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the power cable (1) and data cable (2) from the rear of the optical drive. Press the release
lever on the back of the drive (3), and then slide the drive out of the front of the chassis (4).
CAUTION:
damaging the cable.
30 Chapter 4 Removal and replacement procedures: Small Form Factor
All removable media should be taken out of a drive before removing the drive from the
(Access panel on page
When removing the cables, pull the tab or connector instead of the cable itself to avoid
(Preparation for disassembly on page
19).
18).