Cleaning The Keyboard; Cleaning The Monitor; Cleaning The Mouse - HP ProDesk 400 G2.5 Maintenance And Service Manual

To clean the computer case, follow the procedures described below:
●
To remove light stains or dirt, use plain water with a clean, lint-free cloth or swab.
●
For stronger stains, use a mild dishwashing liquid diluted with water. Rinse well by wiping it with a cloth
or swab dampened with clear water.
●
For stubborn stains, use isopropyl (rubbing) alcohol. No rinsing is needed as the alcohol will evaporate
quickly and not leave a residue.
●
After cleaning, always wipe the unit with a clean, lint-free cloth.
●
Occasionally clean the air vents on the computer. Lint and other foreign matter can block the vents and
limit the airflow.

Cleaning the keyboard

Follow all safety precautions in
keyboard.
To clean the tops of the keys or the keyboard body, follow the procedures described in
Computer Case on page
When cleaning debris from under the keys, review all rules in
before following these procedures:
CAUTION:
keys.
●
Visible debris underneath or between the keys may be removed by vacuuming or shaking.
●
Canned, pressurized air may be used to clean debris from under the keys. Caution should be used as too
much air pressure can dislodge lubricants applied under the wide keys.
●
If you remove a key, use a specially designed key puller to prevent damage to the keys. This tool is
available through many electronic supply outlets.
CAUTION:
improperly removed or installed, the keyboard may not function properly.
●
Cleaning under a key may be done with a swab moistened with isopropyl alcohol and squeezed out. Be
careful not to wipe away lubricants necessary for proper key functions. Use tweezers to remove any
fibers or dirt in confined areas. Allow the parts to air dry before reassembly.

Cleaning the monitor

●
Wipe the monitor screen with a clean cloth moistened with water or with a towelette designed for
cleaning monitors. Do not use sprays or aerosols directly on the screen; the liquid may seep into the
housing and damage a component. Never use solvents or flammable liquids on the monitor.
●
To clean the monitor body follow the procedures in

Cleaning the mouse

Before cleaning the mouse, ensure that the power to the computer is turned off.
●
Clean the mouse ball by first removing the retaining plate and the ball from the housing. Pull out any
debris from the ball socket and wipe the ball with a clean, dry cloth before reassembly.
●
To clean the mouse body, follow the procedures in
14 Chapter 3 Routine care, SATA drive guidelines, and disassembly preparation
General cleaning safety precautions on page 13
13.
Use safety glasses equipped with side shields before attempting to clean debris from under the
Never remove a wide leveled key (like the space bar) from the keyboard. If these keys are
before cleaning the
General cleaning safety precautions on page 13
Cleaning the Computer Case on page
Cleaning the Computer Case on page
Cleaning the
13.
13.