Fan Sink - HP ProDesk 400 G2.5 Maintenance And Service Manual

Fan sink

The fan sink is secured atop the processor with four captive Torx screws. The fan sink includes a heat sink
and a fan.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the fan cable from the system board connector labeled CPUFAN (1).
4. Loosen the four captive Torx T15 screws (2) that secure the fan sink to the system board tray.
CAUTION:
downward forces on the processor. This is especially important as the pins on the socket are very fragile
and any damage to them may require replacing the system board.
40 Chapter 4 Removal and replacement procedures: Small Form Factor
(Access panel on page
Remove fan sink retaining screws in diagonally opposite pairs (as in an X) to even the
(Preparation for disassembly on page
19).
18).