Life Gear 93320 Owner's Manual page 16

7. Computer and Handlebar Installation
56
Remove four M5x10 Bolts (57) from the back of the
Computer (56).
69
Remove two M8x15 Bolts (41) and Ø20xØ8 Curve 6
Washers (42) from the Front Post (5).
67
Insert the Hand Pulse Sensor Wires (69) from the
41
Handlebar (6) into the hole on the Front Post (5) and
57
42
then pull them out from the top end of the Front Post
69
(5). 5
Attach the Handlebar (6) onto the Front Post (5) with
two M8x15 Bolts (41) and Ø20xØ8 Curve Washers (42)
that were removed.
Connect the Sensor Wire I (67) and Hand Pulse Sensor
Wires (69) to the wires that come from the Computer (56)
and then attach the Computer (56) onto the top end of the
Front Post (5) with four M5x10 Bolts (57) that were removed.
Tool:
Multi Hex Tool with Phillips Allen Wrench 6mm
Screwdriver S8, S13, S14, S15
15