Testing The Climb Mill - Matrix Fitness C5X-01 Service Manual

CHAPTER 9: PART REPLACEMENT GUIDE

9.20 TESTING THE CLIMB MILL

ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST
THE MACHINE:
1) Enter Engineering Mode (LEVEL UP and DOWN for 3 seconds) and input the serial number of the console. Also set the Machine Type and
enter Service Mode to verify that the Date and Time are correct.
2) Press the green GO key and begin using the machine. Stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
3) Grasp the hand grips to check for proper heart rate response.
4) Press the LEVEL UP and DOWN keys on the console to make sure resistance is fully functional.
5) Try stepping off the unit to make sure the proximity sensor is fully functional. Also test the STOP key on the grips and the Control Zone for
function. .
60