Speed Sensor Replacement - Matrix Fitness C5X-01 Service Manual

9.17 SPEED SENSOR REPLACEMENT

1) Turn off power and disconnect the cord from the machine.
2) Rotate the 2 plastic clips counter-clockwise to remove the Matrix logoed cover.
3) Disconnect the speed sensor wire (Figure A). NOTE: Use 2 hands to disconnect the speed sensor wire. Do not pull the socket downwards to
disconnect as it will damage the connector.
4) Remove the 2 screws holding the speed sensor plate to the drive set (Figure B), and remove the speed sensor and plate.
FIGURE A
5) Cut the wire tie and remove the screw holding the speed sensor to the speed sensor plate (Figure C), then remove the speed sensor.
6) Reverse Steps 1-5 to install a new speed sensor. NOTE: Install the speed sensor so that the encoder has a distance of 1.5mm from the optic
disk on each side (Figures D & E).
7) Test the Climb Mill for function as outlined in Section 9.20.
FIGURE D
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE C
FIGURE B
FIGURE E
57