Drive Set Replacement - Matrix Fitness C5X-01 Service Manual

9.10 DRIVE SET REPLACEMENT

* NOTE: It is recommended that 2 technicians be present when replacing or removing the drive set. While it is not necessary to
remove the side covers or a set of stairs, it makes it much easier to remove the drive set if these parts are removed for accessibility.
1) Turn off power and disconnect the cord from the machine.
2) Turn the 2 plastic screws counter-clockwise and remove the Matrix logoed covers on both sides of the machine.
3) Turn the brake lever to the right to lock the stairs (Figure A) to prevent movement that could cause injury.
4) Disconnect the speed sensor wire (Figure B). NOTE: Use 2 hands to disconnect the speed sensor wire. Do not pull the socket downwards to
disconnect as it will damage the connector.
FIGURE A
5) Loosen the screw that applies tension to the chain (Figure C).
6) Disconnect the 5 wire connectors at the top of the drive set (Figure D). These include 2 fan wires, 2 ECB wires, and a brake wire.
FIGURE C
7) Loosen the drive set guide screw if tight (Figure E).
8) Remove the 4 screws that hold the drive set to the frame (Figure F).
FIGURE E
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE B
FIGURE D
FIGURE F
47