Mountain Models SwitchBack Senior Assembly Instructions Manual page 29

Put an EZ Servo connector in each of the servo control horns.
4.
Place Z-Bends in the ends of each of the 2 - 24" and 2 - 12" 1/16" diameter wires.
5.
Place the Z-bend ends of the 12" wires into the plywood aileron control horns.
6.
Slide the aileron servo horn EZ Connector onto the wire and then onto the servo. With the
7.
aileron neutral, secure the control rod in the EZ Connector with the screw.
Trim off extra wire about 1-4" on the other side of the EZ connector.
8.
Thread the 24" 1/16" wire through the pushrod housings with the Z-Bend in the front fuselage
9.
area.
10. Install an EZ Connector on the plywood elevator and rudder control horns.
11. Slide the control wire through the EZ connector on the plywood control horn. Place the Z-Bend
through the servo control horn and place the control horn onto the servo.
12. With the control surfaces neutral, install and tighten the EZ Connector screw.
13. Trim off the extra wire about ¼" behind the EZ Connector.
29