Mountain Models SwitchBack Senior Assembly Instructions Manual page 22

Assemble the 3/32" aileron leading edge parts together as shown. ENSURE that they are
4.
straight and fully secured, using weights or rulers, and secure with thin CA.
Glue the aileron leading edge in place on the aileron as shown. Make sure it is FLAT and
5.
STRAIGHT, weighing it down while it is glued.
Trim the Carbon Fiber rods to length and glue them to the trailing edge of the ailerons with
6.
thick CA. Keep your aileron flat while you are doing this or you'll end up with a permanent
warp!
When done, you should have a LEFT and RIGHT aileron as shown.
7.
22