Hangar 9 Phoenix 7 ARF Assembly Manual page 14


21. Pull the previously installed air line out of the wing
near the retract opening and connect the airline to the retract
air cylinder fitting on the retract.

22. Mount the retract in the wing using four #6 x
3/4-inch sheet metal screws. Make sure to route the airline
back into the wing from where it connects to the retract air
cylinder. Make sure the loop is not too tight, as it could kink
and damage the airline.
14

23. Slide the wheel assembly on the strut. Check
that the wheel is pointing straight ahead and parallel to the
fuselage centerline. Tighten the setscrews on the axle mount
to leave marks on the wire strut.

27. File a flat on the wire strut for the setscrews on the
axle mount to secure to.

28. Place the wheel assembly back on the strut.
The distance between the wing and center of teh axle will
measure 5 / -inch (132mm). Tighten the setscrews to
3
16
secure the wheel and axle to the strut. Make sure to use
threadlock on the setscrews to prevent them from vibrating
loose.

29. Repeat Steps 16 through 28 for the remaining retract
strut and wheel.
Hangar 9 Phoenix 7 ARF Assembly Manual