Permanent Settings In Programming Mode; Inserting And Activating The Filter; Setting The Water Hardness - Jura ENA Micro 5 Instructions For Use Manual

Hide thumbs Also See for ENA Micro 5:
Table of Contents

Advertisement

4 Permanent settings in programming mode

4 Permanent settings in pro-
gramming mode

Inserting and activating the filter

Your ENA no longer has to be descaled if you are
using the CLEARYL Blue filter cartridge. If you did
not activate the filter cartridge the first time you
used the machine, you can do this now as follows.
E Perform the 'inserting the filter' operation
without any interruptions. This will ensure
that your ENA always produces its best.
Precondition: Your ENA is ready for use.
T Touch the ; and _ symbols for approxi-
mately 2 seconds.
The ;, _, & and L symbols light up brightly.
!  T  Touch the Filter symbol for approximately
2 seconds.
The Water Tank symbol M lights up.
T Remove the water tank.
T Open the filter holder.
T Insert the filter cartridge into the water tank,
exerting slight pressure.
T Close the filter holder. It will click into place
audibly.
E After three months, the filter will cease to
work. Set the date on the date plate on the
filter holder in the water tank.
T Fill the water tank with fresh, cold water and
reinsert it.
The Coffee Grounds Container symbol ?
lights up.
16
T Empty the drip tray and coffee grounds
container and reinsert them.
The Filter symbol ! lights up.
!  T  Touch the Filter symbol to start rinsing of
the filter
The Y, <, > and ! symbols flash. The filter
is rinsed.
Rinsing of the filter stops automatically. The
Coffee Grounds Container symbol ? lights
up.
T Empty the drip tray and coffee grounds
container and reinsert them.
The Y, < and > symbols flash, the
machine heats up. Your ENA is once more
ready for use.

Setting the water hardness

E If you are using the CLEARYL Blue filter
cartridge and have activated it, there is no
need to set the water hardness.
The harder the water is, the more frequently the
ENA needs to be descaled. It is therefore important
to set the water hardness accurately.
The following water hardness settings are available:
Water hard-
Symbol(s) shown in
ness
display
Level 1:
1 symbol illuminated
1–15 °dH
Y
Level 2:
2 symbols illuminated
Y <
16–23 °dH
Level 3:
3 symbols illuminated
24–30 °dH
Y < >
Example: Change the water hardness setting from
'level 2' (Y <) to 'level 3' (Y < >).
Precondition: Your ENA is ready for use.
T Touch the ; and _ symbols for approxi-
mately 2 seconds.
The ;, _, & and L symbols light up brightly.
&  T  Briefly touch the Descaling symbol.
The &, Y and < symbols light up.
>  T  Touch the Coffee symbol.
The &, Y, < and > symbols light up.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents