Adjusting The Grinder; Ground Coffee - Jura ENA Micro 5 Instructions For Use Manual

2 Preparation
< T Release the Espresso symbol.
The espresso is prepared. The Espresso <
and Coffee strength symbols (; or _) flash.
< T Touch the Espresso symbol as soon as there
is enough espresso in the cup.
Preparation stops. The amount of water for
one espresso is permanently stored.
The Espresso < and Coffee strength
symbols (; or _) flash until the machine is
ready for use again.
E You can alter this setting at any time by
repeating the above procedure.

Adjusting the grinder

You can adjust the grinder on a continuous scale to
suit the degree of roast of your coffee.
NOTICE
If you adjust the consistency of grind when the
grinder is not operating, the grinder adjustment
switch could be damaged.
T Only adjust the consistency of grind when
the grinder is running.
E For a coarser consistency of grind, turn the
switch to the left, for a finer grind, turn it to
the right.
The consistency of grind is correct if the coffee
flows regularly from the coffee spout. In addition a
fine, thick crema forms.
Example: Change the consistency of grind during
the preparation of a 'strong' espresso.
T Turn the coffee spout to the '1 cup' position.
14
T Place a cup under the coffee spout.
T Open the cover of the grinder adjustment
switch.
_ T Touch the Coffee strength 'strong' symbol.
The Coffee strength 'strong' _ symbol lights
up.
< T Touch the Espresso symbol to start
preparation.
T Turn the grinder adjustment switch to the
desired position while the grinder is
running.
The preset amount of water flows into the
cup. Preparation stops automatically.
E Please note that changing the consistency of
grind only takes effect for the second coffee
preparation.

Ground coffee

You can choose to use a second coffee variety, for
example decaffeinated coffee, with the powder
chute for ground coffee.
E Use ground coffee which is not ground too
finely. Very fine coffee can block up the
system so that the coffee only comes out in
drips.
E It is not possible to prepare two cups with
ground coffee. If the coffee spout is in the
'2 cups' position, just one cup is prepared.
E Never add more than one level measuring
spoon of ground coffee.
E The desired specialty coffee must be
prepared within approximately one minute
after filling with the ground coffee.
Otherwise the ENA stops the operation and
is once more ready for use.