Changing The Filter - Jura ENA Micro 5 Instructions For Use Manual

E If the descaling agent comes into contact
with sensitive surfaces (e.g. marble), damage
cannot be ruled out. Clean up any splashes
immediately.
Precondition: Your ENA is ready for use. The
Descaling symbol & lights up.
& T Touch the Descaling symbol for approxi-
mately 2 seconds.
The Coffee Grounds Container symbol ?
lights up.
T Empty the drip tray and coffee grounds
container and reinsert them.
The Water Tank symbol M flashes.
T Remove and empty the water tank.
T Completely dissolve the contents of one blis-
ter (three JURA descaling tablets) in a
receptacle holding 17 oz (500 ml) of water.
This may take several minutes.
T Pour the solution into the empty water tank
and reinsert the tank.
The Descaling symbol & lights up.
& T Touch the Descaling symbol.
The Y, <, > and & symbols flash, water
flows directly into the drip tray.
The operation is interrupted, the Coffee
Grounds Container symbol ? flashes.
T Empty the drip tray and coffee grounds
container and reinsert them.
The Water Tank symbol M lights up.
T Remove the water tank and rinse thor-
oughly.
T Fill the water tank with fresh, cold water and
reinsert it.
The Descaling symbol & lights up.
& T Touch the Descaling symbol.
The Y, <, > and & symbols flash, water
flows directly into the drip tray.
The Y, < and > symbols flash, water flows
out of the drip tray.
The operation is interrupted, the Coffee
Grounds Container symbol ? lights up.
T Empty the drip tray and coffee grounds
container and reinsert them.
Your ENA is once more ready for use.
E If the descaling operation stops unexpect-
edly, rinse the water tank thoroughly.
Descaling the machine without a prompt: You
can initiate the 'Descaling the machine' operation
manually at any time as long as the machine is
ready for use. Touch the ; and _ symbols
simultaneously for approx. 2 seconds. The ;, _,
L and & symbols light up brightly. Continue with
the first prompt (indicated by T) as described in
this section.

Changing the filter

E After 2000 oz (60 liters) of water have flowed
through, the filter will cease to work. Your
ENA will automatically prompt you to
change the filter.
E After three months, the filter will cease to
work. Set the date on the date plate on the
filter holder in the water tank.
E If the CLEARYL Blue filter cartridge is not
activated in programming mode, you will
not be prompted to change the filter.
Precondition: Your ENA is ready for use. The Filter
symbol ! lights up.
! T Touch the Filter symbol for approximately
2 seconds.
The Water Tank symbol M lights up.
T Remove the water tank.
T Open the filter holder and remove the old fil-
ter cartridge.
de
5 Maintenance
en
fr
it
nl
es
pt
ru
19