Table of Contents
Advertisement
TT4000 Series
6.1.5
Winding up the liner in Peel-Off mode (optional)
Figure 7 Guidance of the liner in Peel-Off mode (optional)
In Peel-Off mode, the labels are removed after printing, and only the liner is wound up
internally.
1.
Lift the pinch roller (4) off the rewind assist roller (5).
2.
Remove labels from the first 100 mm of the liner.
3.
Guide liner to the rewinder (2) around the dispense plate (6) and the rewind assist
roller (5).
4.
Hold rewinder (2) firmly and turn knob (3) clockwise until it stops.
5.
Push liner under a bracket (1) of the rewinder (2) and turn knob (3) anti clockwise
until it stops. The rewinder is fully spread, thus gripping the liner firmly.
6.
Turn rewinder (2) anti clockwise to tighten the liner.
7.
Slightly loosen top fixing screw at the locking system with hexagonal wrench and
position the pinch roller (4) centrally to the liner (see 6.7 on page 25).
8.
Close the locking system (4) and tighten top fixing screw at the locking system (4).
9.
Turn lever (7) clockwise to lock the print head.
The label roll is loaded for use in Peel-Off mode.
Operating Instruction
19
Advertisement
Table of Contents
