Table of Contents
Advertisement
TT4000 Series
Figure 13 Removing and installing the tear-off plate
6.7
Removing and installing the locking system
Figure 14 Removing the locking system
Operating Instruction
Removing the locking system
1.
Position printer at edge of table so that the
oblong hole is accessible from below.
2.
Screw out screws (1) (2) and remove
them.
3.
Remove the pinch roller (4) and bottom
plate (3).
Installing the locking system
1.
Position printer at edge of table so that the
oblong hole is accessible from below.
2.
Place the pinch roller (4) into oblong hole
and lightly tighten screw (1) of bottom plate
(3) from above.
3.
Lightly tighten screw (2) of bottom plate (3)
from below.
3.
Align the pinch roller (4) with centre of
label and tighten screws.
25
Advertisement
Table of Contents
