Table of Contents
Advertisement
TrakMark DS Series
5.2.3 Backfeed
Notice!
Feeding back the material to the lower printhead in the cut mode or between print jobs is not advised.
To avoid the backfeed:
► Activate the option "ignore label position" in the printer driver.
5.2.4 Synchronisation in Cut Mode
► To guarantee the correct length of the first label a cut prior print job is required:
► Activate the option "cut before labels" in the printer driver.
Cleaning
6.1 Cleaning Information
Danger!
Risk of death via electric shock!
► Disconnect the printer from the power supply before performing any maintenance work.
The TrakMark DS printer requires very little maintenance.
It is important to clean the thermal printheads regularly. This ensures a consistently good printed
image and reduces premature wear of the printhead.
Otherwise, the maintenance is limited to monthly cleaning of the device.
Attention!
The printer can be damaged by aggressive cleansers.
Do not use abrasive cleaners or solvents for cleaning the external surfaces or modules.
►
Remove dust and paper fluff from the print area with a soft brush or vacuum cleaner.
►
The cover of the printer can be cleaned with a standard cleanser.
6.2 Cleaning the Print Rollers
Accumulations of dirt on the print rollers may impair the media transport and the print quality.
► Lift the printheads.
► Remove media and transfer ribbon from the printer.
► Remove deposits with roller cleaner and a soft cloth.
► If the roller appears damaged, replace it
Operating Instruction
Service Manual.
19
Advertisement
Table of Contents
