Loading Media; Loading Labels From A Roll; Positioning The Label Roll On The Roll Retainer - Hellermann Tyton TT4000 Series Operating Instructions Manual

TT4000 Series
6

Loading media

For adjustments and simple installation work, use the accompanying hexagonal wrench
located in the bottom section of the print unit. See Figure 4, Item 8. No other tools are
required for the work described here.
6.1

Loading labels from a roll

6.1.1

Positioning the label roll on the roll retainer

Figure 4 Loading labels from a roll
1. Open cover (10).
2. Loosen knurled screw (1) and swivel guide (2) upward and push it all the way out.
3. Load label roll on the roll retainer in such a way that the labels can be inserted into
the print head in the right position. The printing side of the labels must be visible from
above.
4. Supplying longer label strips approx. 40 cm
5. Push label roll until it contacts the housing wall.
6. Swivel guide (2) downward onto the roll retainer (3) and push it against the label roll
so that it rests against the supplying media.
7. Tighten knurled screw (1).
Operating Instruction 16