Table of Contents
Advertisement
TT4000 Series
Figure 17 Removing and installing the print head
Removing the print head
1.
Turn lever (10) anti clockwise to lift the print head.
2.
Remove labels and transfer ribbon from the printer.
3.
Remove hexagonal wrench (9) from its retainer.
4.
Lightly keep print head mounting bracket (9) on the print roller with one finger and
screw out screw (8) with the hexagonal wrench and remove it and the washer.
5.
Swivel print head mounting bracket (9) upward.
6.
Remove print head from the print head mounting bracket (9) if necessary.
7.
Loosen both plug connections (2, 3) on the print head and set print head down on a
clean, soft surface.
Installing the print head
1.
Attach plug connections (2, 3).
2.
Position print head in print head mounting bracket (9) in such a way that the pins (6)
are secured in the corresponding holes in the print head mounting bracket (9).
3.
Lightly keep print head mounting bracket (9) on the print roller with one finger and
check for correct positioning of the print head mounting bracket (9).
4.
Screw in screw (8) with washer with the hexagonal wrench and tighten it.
5.
Reload labels and transfer ribbon (see 6.1 on page 16).
Operating Instruction
31
Advertisement
Table of Contents
