5.
Loading media
NOTICE!
For adjustments and simple installation work, use the accompanying hexagonal
wrench located in the bottom section of the print unit. See Figure 4, Item 8. No other
tools are required for the work described here.
5.1.
Loading continuous labels or tubing from a roll
5.1.1. Positioning the label roll on the roll retainer
Figure 6 Loading labels from a roll
1. Open cover (11).
2. Loosen knurled screw (2) and swivel guide (3) upward and push it all the way out.
3. Load label roll on the roll retainer in such a way that the labels can be inserted into the
print head in the right position. The printing side of the labels must be visible from
above.
4. Supplying longer label strips approx. 40 cm
5. Push label roll until it contacts the housing wall.
6. Swivel guide (3) downward onto the roll retainer (4) and push it against the label roll so
that it rests against the supplying media.
7. Tighten knurled screw (2).
Users Manual for T4000+ Series
17