Master/Slave Mode; Reset Options; System Information - Chauvet Intimidator SPOT 355Z IRC User Manual

Master/Slave
Mode

Reset Options

System
Information
Page 20 of 27
The Master/Slave mode allows a single Intimidator™ Spot 355Z IRC unit (the master) to
control the actions of one or more Intimidator™ Spot 355Z IRC units (the slaves) without
the need of a DMX controller. The master unit will be set to operate in either Automatic
or Sound-Active mode, while the slave units will be set to operate in Slave mode. Once
set and connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1. Press <MODE/ESC>.
2. Use <UP> or <DOWN> to choose Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Follow the instructions to set the DMX address to 001.
7. Connect the DMX input of the first slave unit to the DMX output of the master unit.
8. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
9. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in either Automatic or Sound-Active mode.
2. Make the master unit the first unit in the DMX daisy chain.
·
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
·
Do not connect more than 31 slave units to the master unit.
The Reset option will restart the product, but does not change any settings. Using the
Factory Reset option will clear out all customized settings and return the settings to the
factory defaults To reset the software on the Intimidator™ Spot 355Z IRC, do the
following:
1. Press <MODE/ESC>
2. Use <UP> or <DOWN> to choose Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to choose Reset or Factory Reset.
5. Press <ENTER>.
To view information about the Intimidator™ Spot 355Z IRC:
1. Press <MODE/ESC>
2. Use <UP> or <DOWN> to choose Sys Info.
3. Press <ENTER>. The current information about the product will show on the display.
Intimidator™ Spot 355Z IRC User Manual Rev. 1