Table of Contents
Advertisement
4. Check the Refrigeration Circuit
• Visually check that the refrigerant lines do not rub or touch other lines or surfaces and
that the fan blades turn freely.
• Check that the compressor is snug on all mounting pads.
5. Position and Level the Unit
• Units with legs: Level the unit in both the front-to-back and side-to-side directions. Turn
the bottom portion of the legs for height adjustment.
• Units with casters: Place the unit in its final location, then lock the front casters.
6. Install the Shelves (if applicable)
Shelf support clips are provided in the accessory pack.
1) Place the shelf support clips into the pilasters. Indexing holes are provided on the
pilasters in evenly spaced intervals to assist you in positioning the support clips at the
same height.
2) 2 and 3 section units may be equipped with center shelves which should be installed
after the main shelves are in place. The center shelf kit contains additional clip(s) which
support the center shelf when the main shelves on one side of the cabinet are not
aligned with the main shelves on the other side of the cabinet. See Fig. 6. WARNING!
Without this additional support, the shelf assembly could tip under adverse
loading conditions.
Front View
Main Shelf
Fig. 6
9
Top View
Center Shelf
Clip
Main Shelf
Advertisement
Table of Contents
