Toshiba T2000 Maintenance Manual page 99

After the floppy disk is formatted, the following message will appear.
Format complete
Another format (1:Yes/2:No) ?
(5) If you type 1 and press Enter, the display will repeat the message in step (3) above.
If you type 2, the display returns to the DIAGNOSTICS MENU.
3. COPY program
(1) When COPY is selected, the following message appears.
Type select (0:2DD-2DD,1:2D-2D,2:2D -2HD,3:2HD-2HD) ?
(2) Select a media/drive type number and press Enter. A message similar to the one
below will be displayed.
Insert source disk into drive A:
Press any key when ready.
(3) Remove the Diagnostics Disk from the FDD, insert the source disk, and press any
key. The following message will appear and start the copying to memory.
[ FDD TYPE ] : TRACK
[ FDD TYPE ] : HEAD
[ FDD TYPE ] : SECTOR = xx
(4) Remove the source disk from the FDD and insert the formatted work disk; press any
key. The [[ track,head
copying to the target disk. When the amount of data is too large to be copied in one
operation, the message in step (2) is displayed again.
After the floppy disk has been copied, the following message will appear.
[[track, head = xxx x]]
Copy start
[[ track,head
xxx x ]] message will appear and start the
=
= xxx
= x
= xxx x ]]
3-47