Toshiba T2000 Maintenance Manual page 60

6. Enter the desired subtest number from the subtest menu and press Enter. The following
message will appear.
TEST LOOP (1:YES/2:NO) ?
Selecting YES increases the pass counter by one each time the test cycle ends and then
restarts the test cycle.
Selecting NO returns you to the subtest menu after the test is completed.
7. Type in 1 or 2 for the Test Loop and press Enter. The following message will appear.
ERROR STOP (1:YES/2:NO) ?
Selecting YES stops the test program when an error is found and displays the operation
guide on the right side of the display screen as shown below.
ERROR STATUS NAME
Terminates the test program execution and exits to the subtest menu.
1:
Continues the test.
2:
Restarts the test from the beginning of the test.
3:
Selecting NO displays the error status, increases the error counter by one, and resumes the
test.
8. Type in 1 or 2 for the Error stop and press Enter to execute the subtest chosen from the
subtest menu. Table 3-1 in Section 3.3 lists the subtests available for each test on the
DIAGNOSTIC TEST MENU.
Table 3-3 in Section 3.14 describes the error codes and error status for each error.
3-8
[[ HALT OPERATION ]]
1: Test End
2: Continue
3: Retry