Table of Contents
Advertisement
4.
Slightly lift and slide the speaker assembly (C) toward you and disconnect the speaker cable
(D) from PJ11 (E) on the system board (Figure 4-11).
5.
Lift the speaker assembly out of the T2000.
6.
Remove the two 2.5 x 4 mm screws (F) securing the speaker (G) to the speaker holder
(Figure 4-12).
7.
Separate the speaker from the speaker holder. At reassembly, make sure to route the
speaker cable beneath the speaker holder. (Refer to Figure 4-12 above.)
To reassemble the computer, follow steps 1 through 7 in reverse order.
4-16
Figure 4-11 Removing the speaker bracket
Figure 4-12 Removing the speaker
Hide quick links:
Advertisement
Chapters
Table of Contents
