Toshiba T2000 Maintenance Manual page 26

Procedure 2.
Procedure 2
Connector and Cable Check
The battery pack is connected to the system board with the battery cable. The cable may be discon-
nected or damaged. Refer to Part 4 for instructions on how to disassemble the T2000 and then
perform the following checks.
Check 1 Make sure the battery terminal cable is connected to the system board at PJ702.
If this cable is disconnected, connect it and restart the system. If the problem still
exists, refer to Check 2.
Check 2 Recheck the cable using a multimeter. If the cable looks damaged, replace the
terminal assembly and restart the system. If the problem still exists, refer to Proce-
2-12